GU-D08 80173-109-01 2H081202-001 | SGCT Soft Starter Thyristor

Remove as much material as possible by hand to leave an even, bondable surface. Scrape off as much material as possible with a sharp knife, but avoid scoring the PowerCage module. Clean away any loose pieces of gasket before proceeding with the gasket installation. Clean the PowerCage module with a general purpose household cleaner. Do not spray onto the PowerCage module as this promotes electrical tracking. Apply the cleaner to a paper towel and wipe the surface of the PowerCage module where you will apply the gasket. Liberally spray the surface with distilled water, then wipe dry with a clean paper towel. Apply a thin bead of Loctite 454 adhesive to the PowerCage module surface in a zigzag pattern using the original nozzle size. Use the tip to spread the adhesive
around to cover at least 50% of the area. There should be sufficient quantity of adhesive to remain wet long enough for the gasket to be applied. The adhesive uses the moisture in the air as it cures. The higher the humidity the faster the adhesive will cure.