81000-199-52-R | Voltage Feedback Control Module

1. Ensure there is no power to the equipme2. Mark the position of the ribbon cable and wires.3. Remove the screws and lift the ring lugs from the terminals to removethe wires.4. Release the locking mechanism located on each side of the ribboncable connector and pull the ribbon cable straight out to preventbending the pins.5. Remove the 4 nuts that secure the assembly to the side panel.6. Replace with the new assembly securing with all 4 nuts and washers.(See diagram below)7. Replace ring lugs on terminals. Plug in ribbon cable making sure thatit is positioned properly and fitting is secure (locking mechanism isengaged).8. For personnel and equipment safety, ensure both groundingconnections are reconnected to the sensing boa