1440-TBS-J | SPRING CLAMP

Dynamic Measurement Module – The module mounts only on the1440-TBS-J terminal base via a keyswitch and a 96-pin connector. Themodule contains the measurement electronics, and processors.1. Position the terminal base on the 35 x 7.5 mm DIN rail (A).2. Verify that the side connector (B) is fully retracted into the base unit.3. Slide the terminal base unit over tight against the neighboring terminalbase.Make sure the hook on the terminal base slides under the edge of theterminal base unit.4. To lock the terminal base on the DIN rail, press down on the terminal baseunit.If the terminal base does not lock into place, use a screwdriver to open thelocking tab. Press down on the terminal base until flush with the DIN railand release the locking tab to lock the base in place.5. To complete the backplane connection, gently push the side connectorinto the side of the neighboring terminal base.