PCD4.W100 | SAIA Range Module

Analogue input/output module, 6 channels (4I + 2O),12 bit resolutionThe base printed circuit board must first be removed from the modulehousing in order to install a range module. This is done by pressing in thesnap fastenings on either side of the front panel. Then the PCB fasteningscrew on the upper left hand side of the module is unscrewed, so that thePCB can be removed from the casing.At the lowest space A, one range module for 4 input channels with addresses 0 … 3 (+ base address) can be fitted. The upper spaces B and Care each reserved for 1 output channel with addresses 12 and 13 (+ baseaddress).After installing the range modules, close the housing and tighten up thePCB fastening screw again.